Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Apopka, FL
Gate installation in Apopka means planning for sandy soil, storm-season wind loads, and larger lots than you’ll find closer to Orlando. Tampa Gate Company has served Apopka since 2013, and we’re a gate-only specialist: every tech, every truck, every part is focused on gates, not split across other trades. Whether you’re replacing a sagging driveway gate on an older parcel near the lake or adding an automatic gate to a newer build in the 32712 area, one call to (866) 976-0095 gets you a specialist who recognizes your system on sight.
Why Apopka Homes Are Different
Apopka’s housing stock splits into two distinct patterns, and each one changes the gate work we do. West of Lake Apopka and in the older in-town sections of 32703, homes often date back decades, with steel and aluminum swing gates that have outlived their original posts and hinges. These gates sag, bind, and sometimes tear loose from aging wood posts after years of Central Florida humidity. Toward 32712 and the newer subdivisions pushing toward the rural edge, we see builder-installed decorative aluminum gates and automatic driveway systems that were never adjusted for settling soil after the house was finished.
The soil itself is the quiet problem. Apopka sits on sandy Central Florida ground with a high water table. Heavy summer downpours saturate the soil, posts shift, and gates that worked fine in March are dragging on the ground by August. Hurricane-season wind loads then bend frameworks and stress operators, hinge welds, and track brackets. A repair here is rarely just a hinge adjustment; it’s often re-plumbing a post, re-hanging the gate, and re-setting the operator limits so the system works through the next storm cycle.
Styles & brands we work with





Our Main Apopka Services
Most Apopka homeowners call us for one of two reasons: a gate that won’t move or a gate that moves wrong. Here’s what those jobs look like in this area.
Gate Repair in Apopka
A sagging swing gate or a binding slide gate in Apopka usually traces back to post movement in sandy soil or wind-driven frame distortion. We inspect the posts, hinges, rollers, and latch alignment, then re-plumb and re-hang rather than just cranking a hinge and hoping. We repair first, and replacement only becomes the recommendation when repair isn’t the right answer. For the full scope of gate repair work in this area, see our dedicated Gate Repair in Apopka page.

Electric Gate Repair in Apopka
Electric gate acting up? We diagnose the motor, board, and safety loop, not just the obvious. Apopka’s frequent storms put real stress on control boards and safety sensors, and a gate that opens halfway or reverses for no reason usually has a loop-detector or limit-switch fault, not a dead motor. For the full detail on automated and electric gate repair, visit our Electric Gate Repair in Apopka page.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Apopka
New gate installation in Apopka has to account for what the ground does after the concrete dries. Sandy soil and a high water table mean post footings need real depth, and storm season means the frame and operator both get sized for wind load, not just traffic. A gate installed to Orlando standards will often lean within two years here. If you’re adding or replacing a gate on an Apopka property, the right approach is a dedicated Gate Installation specialist who plans the footing, the frame, and the operator as one system.
Automatic Gate Installation
Signs you need it
You’re opening and closing a driveway gate by hand every day, or a manual gate has become a security gap because it’s too easy to leave open.
What it costs in Apopka
Automatic gate installation in Apopka typically ranges from $4,500 to $11,000+ depending on gate size, operator type, and access-control add-ons.
How we do it
We set concrete footings below the sandy topsoil, mount the gate and operator, then wire and calibrate safety loops, keypads, and remotes.
Driveway Gate Installation
Signs you need it
Your existing driveway gate is rusted through, leaning, or too narrow for the vehicles now using it, and repairs would only buy months, not years.
What it costs in Apopka
Driveway gate installation in Apopka typically ranges from $2,500 to $8,000 for a single swing gate, with automatic operators adding from the figures above.
How we do it
We measure the driveway opening, confirm swing or slide geometry against your property slope, then set posts, hang the gate, and adjust swing-out or swing-in operation to the site.
Sliding Gate Installation
Signs you need it
Your driveway has a steep approach or limited swing clearance, so a swing gate can’t open without hitting grade or passing vehicles.
What it costs in Apopka
Sliding gate installation in Apopka typically runs $5,500 to $14,000 depending on gate length, track or cantilever design, and automation.
How we do it
We set the track or rollers on a level, compacted base, hang the gate so it travels without binding, then mount and calibrate the operator and safety edges.
What Gate Installation Costs in Apopka
| Item | Typical range in Apopka |
|---|---|
| Manual swing gate (single) | $2,500 – $6,000 |
| Automatic swing gate (single) | $7,500 – $22,000 |
| Sliding gate (manual or automatic) | $6,000 – $46,800 |
Does a new gate need a permit in Apopka?
Often yes, especially for driveway gates near the right-of-way or any automated system. We check local Orange County and City of Apopka requirements before we dig, and factor any permit cost into your written quote.
How long does gate installation take in Apopka?
A single manual swing gate often takes one day on site; automatic systems with concrete footings, wiring, and access control usually run two to three days. Weather can extend that during storm season.
Brands We Service in Apopka
We work on LiftMaster, FAAC, and Mighty Mule systems specifically, and we keep common control boards, photo-eyes, and loop detectors in local stock for those brands. That means a faster diagnosis and no two-week wait for a board from a distributor. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Apopka, FL
| Service | Typical range in Apopka |
|---|---|
| Gate repair (manual hardware) | $150 – $450 |
| Electric gate repair | $250 – $850 |
| Gate opener repair | $250 – $750 |
| Automatic gate installation | $4,500 – $11,000+ |
| Driveway gate installation | $2,500 – $8,000 |
| Sliding gate installation | $5,500 – $14,000 |
| Manual swing gate (single) | $2,500 – $6,000 |
| Automatic swing gate (single) | $7,500 – $22,000 |
| Sliding gate (manual or automatic) | $6,000 – $46,800 |
| Gate replacement | $1,500 – $5,000+ |
In Apopka, the biggest price movers are post work: sandy soil often means we’re digging out and re-setting footings rather than just swapping hardware. That’s honest work, and it’s the difference between a gate that lasts and one that leans again next rainy season. Every job is quoted in writing and agreed before any work starts, so the number you approve is the number you pay.
Neighborhoods We Serve in Apopka
We work across all three Apopka ZIP codes, 32703, 32704, and 32712, and we’re in these neighborhoods regularly:
- Errol Estate
- Piedmont Park
- Lake Doe Cove
- Rock Springs Ridge
- Sheeler Oaks
Most Apopka repair calls are reached the same day or next business day, depending on parts and scheduling.
Service Area – Cities Near Apopka
We also serve the communities around Apopka, including South Apopka, FL, Clarcona, FL, Zellwood, FL, and Forest City, FL. If your property sits on the edge of any of these areas, the same gate specialists cover your address.
Serving Apopka, FL — Our Local Coverage Area
We’re based in the Apopka area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Apopka
Most Apopka repair calls are reached the same day or next business day, depending on parts. If your gate is stuck open and security is the issue, call (866) 976-0095 and we’ll tell you honestly when we can be there and what the likely fix will cost before we arrive.
Many Apopka subdivisions with HOAs require architectural review before a new gate goes in, especially for driveway or perimeter gates visible from the street. We can usually work with your HOA’s spec sheet, and we’ll flag any red flags in our first visit so you’re not stuck with an approved design, not an installed gate.
Yes. Property managers and landlords across Apopka call us for gate repairs at single-family rentals and small multi-unit properties. We work directly with your tenant scheduling, keep repair notes for your maintenance file, and bill straightforwardly.
If your Apopka gate is sagging, stuck, or refusing to open, call Tampa Gate Company at (866) 976-0095. We’ll quote the repair or replacement upfront, in writing, before any work starts.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Apopka Customers Say
"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Scott Miller"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
— Rachel Meyer"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
— Diego Guzman