Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Gate Repair Across Holiday
Gate repair in Holiday usually means rust, salt, and a mechanism that has seized up long before the gate itself failed. If your driveway gate is stuck, sagging, or the operator just hums and won’t move, that’s what we handle every week in the 34690, 34691, and 34692 zip codes. Tampa Gate Company is a gate-only shop, so the technician who shows up at your house on a canal-front street off U.S. 19 is not a general contractor guessing at a gate. We diagnose the hardware, the motor, and the safety loop together, because in Holiday they tend to fail together. Call (866) 976-0095 and we’ll get a specialist out to look at it.
Why Tampa Gate Company Is Holiday’s Preferred Gate Repair Company
Holiday has a lot of gates and a lot of salt. It’s not a place where a generic fix lasts long. We work on the systems this town actually has: Mighty Mule and LiftMaster operators on aluminum driveway gates, FAAC and BFT units on older electric gates, and a lot of decorative steel that has been fighting the Gulf air for decades. Our Gate Repair team carries corrosion-resistant hinges, sealed latches, and control board parts stocked specifically for the failures we see near the coast. That means fewer return trips and fewer “we’ll have to order the part” conversations.
Noel Carver built Tampa Gate Company around a simple rule: repair the gate before you sell a new one. Homeowners in Holiday tell us the same thing: their gate is fifteen years old, it worked fine until the storms, and they want it working again without a replacement pitch. We respect that. Our quote is agreed on before any work starts, so you know the number before we turn a wrench.
Styles & brands we work with
Sliding Gate Repair in Holiday
Sliding gate repair in Holiday often starts with a wheel that will not turn and a chain or rack that has grown a crust of salt scale. On canal-front properties along the western edge of town, salt spray hits the track daily, and within a season or two the rollers bind and the operator strains until it trips its limit switch. We free the track, replace pitted rollers and fasteners with coated hardware, and realign the rack so the motor is not fighting the gate.
A straightforward sliding gate service call in Holiday typically runs $175 to $325 when we are replacing rollers, brackets, and a section of rack. If the operator’s control board is involved, figure $260 to $520. Both numbers include the diagnosis, and you approve the total before work begins. Call (866) 976-0095 for an exact quote.
Track and Roller Renewal
Near the Gulf, the cheapest steel parts on a sliding gate are the first to fail. We replace rusted rollers with sealed bearing units and swap standard brackets for powder-coated ones that hold up to salt exposure. On gates that have been sitting seized for months, we also check the foundation bolts at the post, because a gate that cannot slide will eventually twist its own mounting point loose.
Operator and Limit Switch Corrections
When a LiftMaster or BFT slide operator stops partway or reverses for no reason, the limit switch and the current-sense settings get blamed first, but in Holiday the real culprit is usually mechanical drag from the corroded track. We correct the mechanism before we reprogram the board. Adjusting a limit switch on top of a bound-up track only masks the problem until the next storm.
Wrought Iron Gate Repair in Holiday
Wrought iron gate repair in Holiday is less about the iron itself and more about the hinges, latch, and bottom rail where water collects and rust does its slow work. The decorative entry gates on the older ranch homes off Moog Road and near the Anclote River parks take direct sun and salt air all day, and the paint eventually blisters at the welds while the hinge pins seize in their barrels.
Hinge and latch replacement on a standard single-driveway iron gate in Holiday runs $140 to $290. If the bottom rail is rusted through and needs a welded patch section, that job is typically $260 to $420. We match the look of the existing ironwork, not just the function, because a patch plate welded onto a decorative gate should not be visible from the street. You get the price before we start, and the number we quote is the number on the invoice.
Corrosion Control and Repainting
The salt air works from the inside out on hollow iron sections. We grind out the flaking scale, treat the bare steel, and prime before paint so the repair does not rust through again in eighteen months. On gates near the canals south of Holiday Lake Estates, we recommend this treatment any time we replace a hinge or a latch, because exposed steel at the repair point becomes the next failure point if it is not sealed.
Post and Frame Straightening
Storm-driven wind loosens gate posts in sandy Florida soil, and a leaning iron gate then drags on the latch side until the lock will not engage. We reset posts with new concrete and correct the gate alignment so the latch catches cleanly. This matters more than most people expect: a gate that does not close and latch is a security opening, not just an eyesore.
Trusted Brands We Service in Holiday
We service Mighty Mule, LiftMaster, FAAC, and BFT systems in Holiday. That covers most residential slide and swing operators in the area, plus a lot of commercial controllers on churches and small businesses near U.S. 19. We keep common control boards, safety sensors, remotes, and keypads on the truck for these brands, which means most Holiday repairs are done on the first visit. When a board is obsolete, we source a compatible replacement and wire it in without trying to sell you an entire new gate package.
Common Gate Repair Problems We See in Holiday Homes
- Salt-seized latches and hinges: On low-lying split-level homes and canal-front properties, the latch bolt corrodes inside its housing until the handle will not turn. We free or replace the hardware and seal the replacement against future salt intrusion.
- Storm-distorted swing gates: Wind loads push gate panels out of square, causing sag at the latch edge and a striker that misses the post by half an inch. We reset the hinges and reinforce sagging corners with welded gussets or turnbuckle kits.
- Battery backup failures: A surprising number of Holiday operators have a dead or missing backup battery. During a summer storm when the power cuts, the gate stays locked and residents are trapped in or out. We test the battery on every repair call and replace it when it cannot hold a charge.
- Keypad and remote failures from humidity: The keypad membrane cracks under UV and the buttons stop making contact, or a remote works only from two feet away because the receiver antenna has corroded. We replace keypads with weather-sealed units and clean or relocate receiver antennas for reliable range from the driveway.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Repair in Holiday, FL
Gate repair in Holiday is priced per job, not per hour, and the range depends on what failed. A stuck latch or seized hinge runs $140 to $290. A sliding gate with corroded track and rollers is $175 to $325. If the operator control board is involved, you’re looking at $260 to $520. Full wrought iron repair with welding is $260 to $420.
The coastal factor is real: Holiday homes need coated hardware and sealed electronics that inland homes do not, and we price the repair with those materials included from the start. We quote the price and you approve it before any work begins. Estimates are free. Call (866) 976-0095 for a specific number on your gate.
We Also Serve Cities Near Holiday
Tampa Gate Company serves Holiday and the surrounding coastal communities. If you’re in Beacon Square, Key Vista, Elfers, or Tarpon Springs, the same gate specialists who work the canal-front streets of Holiday will come to your address. Most nearby calls get same-day or next-day scheduling, and the free estimate applies no matter which side of the Anclote River you are on.
Serving Holiday, FL — Our Local Coverage Area
We’re based in the Holiday area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Holiday
Salt air corrodes the battery contacts and the circuit board traces inside the keypad, and it eats the remote’s button contacts from the inside. The fix is a weather-sealed keypad and a remote stored in a dry spot, but if the corrosion is already there, the keypad usually needs replacement rather than cleaning. Call (866) 976-0095 and we will test your existing keypad before recommending anything.
Yes, on most Mighty Mule, LiftMaster, FAAC, and BFT systems we can add a battery backup so the gate keeps working during a power outage. For Holiday residents, especially those in 55+ communities or people who leave for months at a time, battery backup means the gate is never locked against a resident who needs to get in or out when the lights are out. We check the existing wiring and the operator’s charging circuit on the same visit.
The typical fix is hinge realignment and post reinforcement. Wind loads distort the frame, and the hinge screws pull loose from softened wood or block. We re-set the post or add steel reinforcement behind the hinge plate, then square the gate panel so the latch engages reliably. A sag correction on a single swing gate in Holiday usually runs $175 to $325 including hardware.
Yes. We remove the flaking rust, weld in new steel where sections have thinned, and treat and repaint the repair area. The hinge barrels and the bottom rail are usually the worst spots on Holiday iron gates, and we replace those parts rather than paint over them. After the repair, the gate closes and latches the way it did when it was installed. Call (866) 976-0095 for a free estimate.
Your automatic gate should have a safety loop, a reversing edge or photo eyes, and a working battery backup if it is your only access point. In Holiday, the safety loop sensors under the driveway are prone to salt corrosion at the wire splices, so we test them on every electric gate repair. A gate without a working safety reverse is a serious injury risk, especially around children and pets, and we will not bypass a safety device to make a gate run.
Contact Tampa Gate Company for Gate Repair in Holiday
If your gate is stuck, sagging, or the operator quit after the last storm, call (866) 976-0095. We serve all of Holiday, including the canal-front streets along the Gulf, the neighborhoods east of U.S. 19, and the 55+ communities throughout Pasco County. You’ll get a specialist who knows your gate brand, a quoted price before work starts, and a repair that stands up to salt air and storm season. Estimates are free.
Written by Noel Carver, Owner at Tampa Gate Company, serving Holiday since day one.